View and Download Health-O-Meter 752KL user manual / care instructions online. Digital Waist-High Scale. 752KL Scales pdf manual download. Also for: 599kl, 597kl. View and Download Health O Meter Nuyu HNY100 user manual online. Activity Monitor. Nuyu HNY100 Fitness Electronics pdf manual download.
6
TROUBLESHOOTING
498KL
Refer to the following instructions to check and correct any failure before contacting service personnel.
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
Scale does not turn on
1. Battery problem
2. Bad Power Supply or Not Plugged In
3. Electrical Outlet not functioning
1. Check / Replace the batteries
2. Check / Replace Power Supply Adapter
3. Use a different outlet
“LobAt”
shows in display
The batteries are low
Replace batteries according to instructions
Questionable weight or
the scale does not zero
1. External object interfering with the scale
2. The display did not show “0.0” before
weighing
3. Scale is not placed on a level surface
4. Scale is out of calibration
1. Remove interfering object from the scale
2. Ask the patient to step off the scale. Zero the
scale and begin weighing process again.
3. Place scale on level surface
4. Check weight with know weight value
“OVER”
shows in display
Overload. The load on the scale exceeds scale
capacity (500 lbs / 220 kg)
Remove weight, turn scale off, turn scale on again
and try again
“UNDER”
shows in display
Negative weight, indicating a tare was present.
Load on the scale is below initial zero point
Clear scale of any weight and re-zero scale by
pressing ZERO button
CALIBRATION
This scale has been factory calibrated and does not require calibration prior to use.
The calibration procedure may be performed using a known weight in either pounds or kilograms. Simply set the scale for the desired
unit of measure using the lb/kg key and start the calibration procedure. The calibration is performed using lb or kg, according to the unit
of measure used upon entering into the calibration path, meaning the scale will default to either lb or kg, if that was the setting left on
the scale for weighing. Note: Calibration weight must be no less than 100 lb (40 kg) and no more than 500 lb (200 kg).
ACTION
DISPLAY SHOWS
Press and hold the LB/KG and ZERO buttons at the same time, then press the ON/OFF
button to turn on the scale. “CAL” followed by a number indicates you can calibrate.
“CAL” then
“XXXXX”
Press the ZERO button. “C-100” (for lb mode) or “C-40” (for kg mode) will flash on the
display and then the display will return to “0”.
“C-100” or “C-40”
Place 100 lbs or 40 kg on the scale and when calibration number stabilizes, press the ZERO
button. “C-200” (for lb mode) or “C-80” (for kg mode) will flash on the display and then the
display will return to “0”.
“C-200” or “C-80”
Place 200 lbs or 80 kg on the scale and when calibration number stabilizes, press the ZERO
button. “C-300” or “C-120” will appear on the display and then the display will return to “0”.
“C-300” or “C-120”
Place 300 lbs or 120 kg on the scale and when calibration number stabilizes, press the ZERO
Health-o-meter Scale Manual
button. “C-500” or “C-200” will appear on the display and then the display will return to “0”.
“C-500” or “C-200”
Health-o-meter Professional Scale User Manual
Place 500 lbs or 200 kg on the scale and when calibration number stabilizes, press the ZERO
button. “ END ” will appear on the display and then the scale will automatically turn off.
“END”